Introduction
Tools
- 
                  
                  - 
            To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver. 
- 
            The location of the other two screws are marked in red. 
 
- 
            
- 
                  
                  - 
            After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. 
 
- 
            
- 
                  
                  - 
            Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger. 
 
- 
            
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.