Introduction
This is a simple guide that will open up the car's insides and allow more access to the other parts of the car.
Tools
- 
                  
                  - 
            Use the 3 mm Philips #1 screwdriver to remove the three 3 mm screws that connect the front panel with the main underside panel. Also remove the 6 mm front panel screw. 
- 
            Remove the bottom panel by pulling the plastic tabs from either side of the car. 
 
- 
            
- 
                  
                  - 
            Remove the two 6 mm screws and the two 3 mm screws that connect the back panel to the main underside panel. 
- 
            Remove the two 6 mm screws that connect the rear panel to the body of the car. 
 
- 
            
- 
                  
                  - 
            Remove the two front 6 mm screws and the two middle 6 mm screws. 
- 
            Remove the car shell and place it on the left side of the car. 
 
- 
            
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.