Introduction
Winterization of the recreational vehicle so that it can spend the winter without problems
Steps to follow to be able to winterize a typical trailer.
- 
                  
                  - 
            The undersides of the trailers are only protected by a tarpaulin. 
- 
            Items passing through this tarp leave openings for rodents or other insects 
- 
            Patch those holes with duck tape 
 
- 
            
- 
                  
                  - 
            With a soft brush and a soap brush clean the exterior of the trailer 
- 
            Make sure it's completely dry before bringing it indoors if that's what you're doing. 
 
- 
            
- 
                  
                  - 
            After the exterior cleaning, it is an ideal moment to rinse with plenty of water the bumper which also serves as a storage for the sewer pipe. 
- 
            Thoroughly rinse the inner bumper 
- 
            Thoroughly rinse the pipe 
- 
            Leave everything to air dry for a day. 
- 
            A good idea to suspend the pipe so that it drips completely 
- 
            Put it all back in the bumper 
 
- 
            
- 
                  
                  - 
            Close the refrigerator by pressing OFF 
- 
            Taking tea towels, place it at the bottom of the refrigerator and leave the door open 
 
- 
            
- 
                  
                  - 
            The next day, clean dry the inside 
- 
            Place baking soda during hibernation 
- 
            Place scraps of wood so that the freezer compartment can breathe and have air 
- 
            If possible open the door ajar during hibernation 
 
- 
            
- 
                  
                  - 
            With a jet nozzle clean the toilet until no more deposits remain and your outlet water is clear 
- 
            If you are not connected to a drain, you can use a bucket and gloves 
 
- 
            
- 
                  
                  - 
            The valves are placed in such a way as to allocate cold water into the water heater and out. The cold-hot junction valve is closed 
- 
            Open valves to prevent cold water from entering and hot water from exiting. Open the cold-hot junction valve 
 
- 
            
- 
                  
                  - 
            To drain the water heater, the anode must be unscrewed with a 1 and 1/16 inch socket. 
- 
            Release pressure by pressing the valve repeatedly 
- 
            Unscrew the anode completely and let the water flow completely out of the water heater 
- 
            The teflon tape will be to replace that of the anode next spring 
- 
            Once empty replace the anode 
 
- 
            
- 
                  
                  - 
            Turn the valve down (for my system) and the pump will draw liquid from the food grade antifreeze container 
- 
            Start the pump 
 
- 
            
- 
                  
                  - 
            Always one faucet at a time, start with the sink cold water stop when the antifreeze comes out fully pink 
- 
            Continue with the hot water tap 
- 
            Go use the toilet 
 
- 
            
- 
                  
                  - 
            Open bath cold water faucet, stop when antifreeze comes out 
- 
            Do not forget to shower, water accumulates there. 
- 
            Open hot water tap, stop when antifreeze comes out 
 
- 
            
- 
                  
                  - 
            Take the fire extinguisher, shake it to stir the powder inside 
- 
            You can knock it lightly on a padded surface 
- 
            Remove any type of fabric likely to be undone by mice or rodents: tissues, paper towels, etc. 
- 
            Finally, place Bounce sheets under mattresses and other pillows. 
- 
            Placed in places near an exterior mouth keep mice and other rodents away with their scent 
 
- 
            
- 
                  
                  - 
            Disassemble the tank, tie the wires securely so they don't hang or catch anything along the way. 
- 
            Burn the excess gas via the rings, the fridge, the water heater. As soon as the flame starter clicks stop 
 
- 
            
- 
                  
                  - 
            Close the circuit breakers so as not to draw all the energy from the battery of the towing vehicle during the trip to storage 
- 
            Disconnect the battery and store it out of the gel on a wooden or plastic surface. Anything but concrete. Recharge the battery once or twice during the winter and before leaving with the trailer 
- 
            Tie the battery wires securely 
- 
            Open drain plugs to remove excess water 
 
- 
            
- 
                  
                  - 
            Possibility of leaving things that do not fear the cold. Plastic tips, empty and dry pipes, tools, etc. 
- 
            Lock all compartments and doors. 
- 
            Leave interior doors open during hibernation 
- 
            If a Max-Air is present leave a very small gap on the roof vent 
 
- 
            
In spring the steps are almost the opposite