Vivotek FD8169 Camera Module Replacement

Written By: Logan Bento
  • Comments: 0
Vivotek FD8169 Camera Module Replacement

Difficulty

Moderate

Steps

7

Time Required

5 - 10 minutes

Introduction

  1. mtudHFdcwvZFL1wl

    • Loosen the outside screw.

  2. fPAquDoGD5YBXNyR

    • Press down on the side button, and lift up the top dome.

  3. aJEiM1gONiUDZDnD

    • Remove three screws that connect the camera base to the motherboard using a Phillips #1 screwdriver.

  4. 4QiBjefUAtDwtQkr

    • Lift off the camera base from the motherboard.

  5. bcJSkEeoyDZGtwKk

    • Unscrew the cord from the motherboard.

    • Unplug the remaining connection.

  6. kgXCnYtBtWc33GYV

    • Unscrew the camera from the camera base with a hex screwdriver on both sides.

  7. FrEI6MgtoMpWtTHi

    • Pull the camera out from the camera base.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Logan Bento

Member since: 19/10/21

169 Reputation

0 comments