Introduction
This guide will show how to safely remove the back panel of the Toshiba Satellite C55D-B5206 step-by-step to access various internal components including the hard drive, fan and CD drive. Accessing the internal components gives you the access to resolve issues like a slow or failing hard drive, malfunctioning fan, and in this case, a malfunctioning CD drive. The goal is to replace your CD-ROM drive if it has incompatible disk issues, faulty disks, corrupt registry entry, or the drive hardware failed. CD-ROM drive allows you to use CDs, DVDs, and Blu-ray discs to listen to music, watch a movie, or access files. It is usually used to consume media stored in discs. Your CD-ROM drive could be failing to load or boot up the content held on the discs, which is why you may want to replace it. For this repair a Philips#1 screwdriver, iFixit opening tool, and a spudger are required as you are going be unscrewing and prying open parts. You are going to be required to detach the CD-ROM drive from the connector port and replace it with a new one. Before beginning, make sure the laptop is powered off and disconnected from any power sources. You are going to be required to use a spudger, we highly recommend to use a plastic spudger as a metal one can damage your laptop's internal hardware or the exterior. Throughout the repair process, you may hear slight clicking noises or a bit of resistance when removing parts such as the battery, these are usually normal. Once you’ve completed the process, simply follow the steps in reverse to reassemble your laptop.
Tools
Parts
-
-
Turn the laptop upside down so the battery faces upwards.
-
Using the Philips screwdriver, unscrew the two, 7 mm Phillips screws that secure the battery.
-
-
-
Place both your thumbs on the outside edges of the battery that meet the device.
-
Push the battery out and away from the laptop.
-
-
-
Use the screwdriver to remove the thirteen, 7 mm Phillips#1 screws from the bottom of the chassis.
-
-
-
Insert a spudger at the center and into the crevice between the bottom casing and the keyboard and pry upwards.
-
Gently slide the spudger along the entire perimeter of the device and pry the casing loose to unhook 6 clips.
-
-
-
Remove the 7 mm Philips#1 screw in the back casing removal.
-
Place thumb on the edge of the CD-ROM drive and gently slide the CD-ROM drive towards your palm.
-
To reassemble your device, follow these instructions in reverse order.