Toro Stump Grinder SGR-13 22615HD 2017 Belt Guard Replacement

Written By: Sam Omiotek
  • Comments: 1
Toro Stump Grinder SGR-13 22615HD 2017 Belt Guard Replacement

Difficulty

Moderate

Steps

6

Time Required

15 - 30 minutes

Introduction

Follow this guide to replace the belt guard on a 2017 Toro Stump Grinder SGR-13 model 22615HD.

  1. yKTFtGTSVQfykedP
    yKTFtGTSVQfykedP
    rQrRWTllVbdORPGN

    • Before you begin, ensure the machine is powered down and cool to the touch.

    • Turn the ignition switch to the off position.

  2. w4qVvtTBVYLNxnoH
    w4qVvtTBVYLNxnoH
    VpyJUWCREOdcS1Wr

    • Flip the fuel cutoff valve switch into the off position.

  3. IvkPJmyDZKumZeDG
    IvkPJmyDZKumZeDG
    3cqjLbt2Xr6TrZ2X

    • Grab the plastic housing at the end of the spark plug wire.

    • Pull firmly to disconnect the wire from the spark plug.

  4. TIvnuMVh3VW4ZLwF

    • Tilt the machine so that it is resting on the handle with the cutter wheel raised.

  5. p2mNVIFneCgZfZRc
    p2mNVIFneCgZfZRc
    NrXJR4QyDeMNmXDJ

    • Use a 14 mm socket to remove the fasteners securing the belt guard:

    • One 10 mm bolt

    • One 10 mm nut

    these are 10mm fasteners, not 14mm , measure the distance from the outer thread on one side to the outer thread on the other side, this is called : major diameter

    JAMES -

  6. bAbCCZYDsbMONTMI
    bAbCCZYDsbMONTMI
    oGQTpeoXUMXOnuOO
    cinNfILAgouCHL5M

    • Remove the belt guard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Omiotek

Member since: 25/02/19

81109 Reputation

0 comments