Introduction
Use this guide to refill and empty stapler, so you can get back to those TPS reports.
-
-
Grab the base of the stabler, and pull the hammer until the stapler opens, revealing the carrier, pusher, and spring.
-
Identify the staple type by looking on the bottom of the carrier. If the staple type is not on the carrier, look under the base.
-
-
-
Get a cluster of staples and carefully place it in the carrier.
-
Make sure there is enough room for the pusher to contact the staples.
-
Close the stapler by clearing your hand from under the crimp area and pushing the hammer down until a clicking sound is heard.
-
To reassemble your device, follow these instructions in reverse order.
2 comments
Wnen I tried to load the staples, the spring came loose. But I do not know where to reconnect it and have a loose short plastic rod!
@ cookie clicker When I attempted to load the staples, the spring became detached. However, I'm unsure where to reattach it, and I now have a loose, short plastic rod.