Introduction
If the power button on the device is faulty or not working then this guide will show the reader how to replace it.
-
-
Using the Phillips head screwdriver PH000, remove the two 1.4 mm screws that are located on the backside of the device.
-
-
-
Slide the back cover off by pushing it to the left, away from the side that held the screws.
-
Remove the cover.
-
-
-
Once the back cover has been removed locate the battery in the bottom right corner of the device.
-
Using the pointed end of the spudger, push out the white plug that is connected to the battery from its beige base.
-
-
-
Use the flat end of the spudger to pry the battery out of its holder. There may be glue holding it in place.
-
-
-
Using the Phillips screwdriver remove the 1.4 mm screw from the top panel.
-
Using the same screwdriver, remove the 1.4 mm screw from the back of the device.
-
Pry apart off the top panel of the device.
-
To reassemble your device, follow these instructions in reverse order.
