Sony Cyber-shot DSC-W800 Lens Replacement

Written By: Thomas Campo
  • Comments: 1
Sony Cyber-shot DSC-W800 Lens Replacement

Difficulty

Moderate

Steps

8

Time Required

20 - 25 minutes

Introduction

Some things to consider before you work on the Sony Cyber-shot DSC W800 to replace the Lens:

  • The Lens is an integral part of the device and any improper handling can cause issues in other parts of the camera.
  • Be cautious when removing ribbon wires.
  • Be sure to keep track of all pieces that are taken apart.

  1. GUpTQtwboDrXYMtm
    GUpTQtwboDrXYMtm
    6JWdBUKJNLKdTRcU
    lUfZpSNNexmO1f6T

    • Remove the five 4.0 mm Phillips #000 screws on the back panel.

  2. outaTM3MNyES5oSc
    outaTM3MNyES5oSc
    c2jbyUXMKFHrOoVr

    • Using the Spudger, remove the back panel from the device.

    • The loose piece circled in the picture will most likely fall off the camera housing.

  3. NOEynXhFVV3QPweD
    NOEynXhFVV3QPweD
    lIJhSDlqMRpkTHcd
    vVLNlgUj1FpBeUZh

    • Remove the two 2.15mm Phillips #000 screws from the circuit board.

    • Gently pull on the ribbon wire from ZIF connector with the tweezers to remove the button board.

    • Ribbon wires can easily be damaged.

  4. vovXEsjq5UljFZR4

    • Remove the four 3.75 mm Phillips #000 screws from the LCD back panel.

  5. rIvy3mqNYEgtwnOH

    • Lift the back panel and separate the LCD Screen by prying it up.

    • Remove the back panel.

  6. PX6lfORPLn2gNEkF
    PX6lfORPLn2gNEkF
    n4liU2PYyR6aY1es

    • Gently pull on the ribbon wire disconnecting from the ZIF connector (connecting the LCD screen to the motherboard) with the tweezers.

    • Ribbon wires can be easily damaged.

    Informações errada, primeiro levante a trava do conector, trava preta do cabo para cima, não puxe sem levantar a trava

    Renato Cardoso -

  7. xBmnKZMrXSO6oph1
    xBmnKZMrXSO6oph1
    gWCjBb1K44l62XXs

    • With plastic opening tool, gently pry loose the front panel.

    • Separate front panel from the camera housing.

  8. 2OLSAdrvmW4J2YHF
    2OLSAdrvmW4J2YHF
    QKPlAcFedFNOriAV
    O2VEKWfCyFBrU5ZO

    • Remove the lens housing by pushing it, from the front, through the housing and lifting it out.

    • Gently pull on the large ribbon wire (connecting the Lens housing to the motherboard via ZIF connector) with the tweezers.

    • Gently pull on the small ribbon wire (connecting the Lens housing to the motherboard) with the tweezers.

    • Be careful not to damage either of the ribbon wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Thomas Campo

Member since: 09/02/16

809 Reputation

0 comments