Sony Cyber-shot DSC-T1 CCD Sensor Module Replacement

Written By: iDeleted
  • Comments: 1
Sony Cyber-shot DSC-T1 CCD Sensor Module Replacement

Difficulty

Easy

Steps

6

Time Required

1 minute

Introduction

Is your LCD screen acting strange? Replacing the CCD Sensor Module is a straight forward task that will increase the clarity of your screen.

  1. LIqAO2axT5tQyEZk
    LIqAO2axT5tQyEZk
    wv5tqGMYrQIr3KSd

    • Locate the battery door at the bottom of the camera.

    • Press down on the door and slide it back. The door will pop open.

  2. 6FYuZBMbTJ2YZPWl

    • Remove the battery from the door that you opened in the previous step.

  3. lVLDWTNZSPK3otA6
    lVLDWTNZSPK3otA6
    gfCyPgT2woJ3yyHj
    NVu4BYsuyORP2jPH

    • There are two screws on the left and right sides of the camera, and two screws on the bottom.

    • Use a PH00 screwdriver and remove the six 2.9mm screws.

  4. SaZIDW2GWVxApNkf
    SaZIDW2GWVxApNkf
    f2NIGkQgvhoSkBAD

    • Use hands to gently pry the front casing away from the camera.

  5. i6vSVy1JEKvMYUIm
    i6vSVy1JEKvMYUIm
    CAhxo3XYPqF1sGg2

    • Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.

    • The second picture shows what these tabs look like in their open positions.

  6. PcCRQm5ugiUUh45Y

    • Grasp the CCD Sensor Module and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

iDeleted

Member since: 07/07/10

2101 Reputation

One comment

where I can buy it?

Francesco Cortese -