Samsung Refrigerator Evaporator Cover (Refrigerator Compartment) Replacement

Written By: Arthur Shi
  • Comments: 2
Samsung Refrigerator Evaporator Cover (Refrigerator Compartment) Replacement

Difficulty

Moderate

Steps

9

Time Required

No estimate

Introduction

Prereq guide to remove the refrigerator evaporator cover.

  1. SaOfLbkeAxgmho5g

    • Unplug your refrigerator before you begin your repair.

    • If you are testing or repairing the following items, you may also need to shut off and disconnect the water supply:

    • Condenser fan motor

    • Compressor motor and thermal overload device

    • Water supply valve assembly

  2. O2XGt1FbR2wqssVR
    O2XGt1FbR2wqssVR
    L5gfkBAXIADyme3l

    • Open both French doors for the refrigerator compartment.

  3. EZ1pcx3sRXWP5OmZ
    EZ1pcx3sRXWP5OmZ
    KSCZFQWUTJMhLEZO

    • Remove all the loose shelves and bins from the refrigerator compartment.

    • The bottom shelf is clipped in place. Follow the next step to remove it.

  4. ncCDecLMOiqwRlDA
    ncCDecLMOiqwRlDA
    x3hVWFLnaXhGByxL
    lOUYFLy52ICUKRyR

    • Two stiff plastic tabs (one on each side) secure the bottom shelf in place.

    • Press both plastic tabs firmly with your fingers and lift upward to unclip the bottom shelf.

    • If the shelf doesn't unclip, you can try using a flathead screwdriver to press each clip in.

    • Remove the bottom shelf.

  5. XeJcGVxpbG1bXROm
    XeJcGVxpbG1bXROm
    3osilVrkkDwHykuk
    lAORpBvWcLnl2XhV

    • Use a flathead screwdriver to pry and remove the top screw cover on the evaporator cover.

  6. jSdUKMSNIuDQBrl1

    • Remove the screws securing the evaporator cover.

  7. rngXuZCPImQScTVw
    rngXuZCPImQScTVw
    w1cnHpjLvQ5cdtcD
    tMKZ3cEVSftCFHHY

    • Grasp the right edge of the evaporator cover with your hands and swing it outwards toward you.

    • Don't try to fully remove the cover in this step, as it's connected by several wires.

    if you see signs of ice buildup, let things thaw before you go further- in my case, the evaporator coils were covered with ice, which had reached the point where it was hitting the fan blades. My whole cover was frozen in place, which made removing it without wrecking the Styrofoam insulation very difficult.

    Doug Snook -

  8. 2LvrUGYhYkNTHJMI

    • Squeeze and disconnect all the wire connectors connecting the evaporator cover to the refrigerator.

  9. N2c1y1McoTuqPOAT
    N2c1y1McoTuqPOAT
    uT5K6IJUesPN3AtK

    • Pull the evaporator cover towards you and remove it.

    If your issue is ice build-up, the evaporator cover may be frozen in place. If you can, leave the fridge open and let things thaw for a while before you try to open it (and the ice might be your whole problem anyway, so you may solve the problem right there)

    Doug Snook -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Arthur Shi

Member since: 03/01/18

272294 Reputation

0 comments