Introduction
The back cover holds the screen in place and protects the internal components of the camera.
Tools
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove one 6.4 mm screw in the center of the dial. 
- 
            Remove the dial by lifting upward with your fingers. 
 
- 
            
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove the four 5.5 mm screws surrounding the viewfinder. 
- 
            Use your fingers to lift the plastic viewfinder cover upward. 
 
- 
            
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove the two 5.5 mm screws from the right side of the camera above the SD card port. 
 
- 
            
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove one 5.5 mm screw on the left, above the HDMI port. 
 
- 
            
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove the five 5.5 mm screws from the bottom, near the battery compartment. 
- 
            Use the Phillips #00 screwdriver to remove one 3.8 mm screw from the bottom of the hand grip, below the battery compartmen. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.