Ryobi P501G Blade Replacement

Written By: Eeshan Mishra
  • Comments: 0
Ryobi P501G Blade Replacement

Difficulty

Moderate

Steps

4

Time Required

15 minutes

Introduction

If your Ryobi P501G starts failing when using your saw, you may want to think about replacing the component. The failure may be a result of heavy use or a crack. The replacement of the blade is not complex. You will need the indicated screwdrivers and a spudger to complete this task. There are no warnings or potential hazards when replacing this part.

  1. HibLmxvPTJ5EtMZG

    • Locate the area where the blade is connected to the motor, where the circular covering is on the Ryobi P501G.

  2. ZKjwKKJKgVlhoAkg
    ZKjwKKJKgVlhoAkg
    qneQX2DmvRJWWytV

    • Unscrew clockwise and remove the bearing in the middle, connecting the blade to the motor. This will also allow removal of the blade guard.

  3. PclxHqYoPJBsw3lJ
    PclxHqYoPJBsw3lJ
    MOV1ERDFbQhEw4yt
    PPMKub2PVQfl3uvn

    • Remove the four black screws holding the black bearing and remove the bearing itself.

  4. LFTWPm2kpvTD6fDU

    • Once the black bearing is off, remove the transparent cover of the blade.

    • Once the cover is off, remove the blade.

    • Place the new blade with the flat notches lined up with the flat notches on the motor axle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eeshan Mishra

Member since: 24/01/19

424 Reputation

0 comments