Replacing Sanyo VPC-X1200 Rear Buttons

Written By: Anthony Giardina
  • Comments: 0
Replacing Sanyo VPC-X1200 Rear Buttons

Difficulty

Easy

Steps

3

Time Required

5 minutes

Introduction

This is an easy guide to replacing the rear buttons on the Sanyo VPC-X1200.

  1. nWWunZCYDCOM4Tun
    nWWunZCYDCOM4Tun
    cWFjUCjaMKVyKjTR
    INNm3vJGe4yW3cNa

    • Remove the five case screws with a Phillips #00 Screwdriver.

    • Five 3.5mm Phillips Screws

  2. 3fs5LCDPf5yjEOMx

    • Gently lift up the back cover and set aside.

  3. tSoSlJxFsSNxEcfM

    • Use small plastic pry tool to gently remove rear button plate.

    • A heat gun may be used to soften the glue for easier removal.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Anthony Giardina

Member since: 19/04/10

20 Reputation

0 comments