Introduction
In order to perform any sort of repair on the throttle body unit, it must first be removed from the engine by following these step by step instructions
Tools
- 
                  
                  - 
            Firstly Disconnect battery 
- 
            Always take the negative terminal off first. 
- 
            '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job 
 
- 
            
- 
                  
                  - 
            Locate throttle body on right side of engine, it is between the intake tube and intake manifold. 
 
- 
            
- 
                  
                  - 
            Use a flat head screwdriver to loosen the hose clamp attaching the intake tube to the throttle body. 
 
- 
            
- 
                  
                  - 
            Locate throttle linkage arm. 
- 
            Open the locking clip with a flat head screwdriver. 
- 
            Pry off the linkage arm with a flat head screwdriver. 
 
- 
            
- 
                  
                  - 
            Locate the three 13mm nuts attaching the throttle body to the intake manifold. 
- 
            Remove nuts with a 13mm crescent wrench. 
 
- 
            
- 
                  
                  - 
            Lift the throttle body off of the intake manifold. 
- 
            The manifold is now out of the engine bay and ready for cleaning or adjustment. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.