Introduction
Two tools required for the completion of this task include a PH1 screwdriver, and a prying tool.
All screws on this device are 10mm (0.393 in).
Tools
- 
                  
                  - 
            Using a Phillips #1 screwdriver, remove the 3 screws holding the black plastic cover in place. 
- 
            Pull upwards and remove the black plastic cover. 
- 
            Remove the ceramic plate by pulling the plate parallel to the straightener, while pulling upwards. 
 
- 
            
- 
                  
                  - 
            Using a Phillips #1 screwdriver, remove the 3 screws holding the black plastic cover in place. The screws are located in the same places as the other side. 
- 
            Pull upwards and remove the black plastic cover. 
- 
            Remove the two screws off of the chip using a Phillips #1 screwdriver. 
- 
            Pull off the chip with the same method as the black plastic cover. 
 
- 
            
- 
                  
                  - 
            Remove the ceramic plate by pulling the plate parallel to the straightener, while pulling upwards. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.