Introduction
This guide will show how to replace the LCD screen on the RCA RCR8622.
Tools
- 
                  
                  - 
            Remove the casing. Slide the plastic cover with the graphic off the main base. Be careful and hold both sides. 
- 
            Flip the device over and unscrew the five 11 mm screws with a Phillip's #1 screwdriver. 
 
- 
            
- 
                  
                  - 
            Pull the top of the device off and look closely at the motherboard. You will see two speakers, one on each side of the device. 
- 
            Grab the tweezers and follow the red and black wires leading from the speaker to the motherboard. They will attach to a white casing. Lift the white plug out with the tweezers to disconnect. 
 
- 
            
- 
                  
                  - 
            Remove the two 11mm screws from the motherboard with the Phillip's #1 screwdriver. 
- 
            Squeeze the 2 metal prongs on the interior of the motherboard inward until a clicking noise is heard. 
 
- 
            
- 
                  
                  - 
            Lift the motherboard out of the interior of the device. 
- 
            Remove the screen section of the device by lifting upward on the circuit it is connected to by sliding it upwards. 
 
- 
            
- 
                  
                  - 
            Flip both components of the circuitry over and from the main motherboard you will see metal pins that lead to the LCD screen. 
- 
            Heat the solder around the pins with a soldering iron so the pins can be removed and the screen can be detached. Use a flat object to help push out the pins. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.