Introduction
This guide will instruct on how to replace a malfunctioning Viewfinder assembly on the RCA CC310.
Tools
- 
                  
                  - 
            Slide a spudger between the plastic rail and the metal tab on the left side of the rail. Push away from the camcorder to release the flap. 
- 
            Slide the lifted flap towards the viewfinder assembly until the viewfinder is free from the rail. 
 
- 
            
- 
                  
                  - 
            Unscrew the 7mm ph#0 screw on the underside where the cable connects. 
- 
            Lift the plastic where the cable connects off of the viewfinder assembly. 
- 
            Disconnect the cable inside by pulling it apart. 
 
- 
            
- 
                  
                  - 
            Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly. 
- 
            Lift the viewfinder plastic assembly up and remove. 
 
- 
            
- 
                  
                  - 
            Lift the microphone circuit board straight up. 
- 
            Unclip the cable connected to the circuit board. 
 
- 
            
- 
                  
                  - 
            Lift plastic housing and guide the wires from underneath. 
- 
            Lift out the entire circuit board and viewfinder. 
- 
            Replace entire circuit board and viewfinder assembly. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
One comment
do you know where i can find a relacement one of these parts