Introduction
This guide will instruct you to replace the effect button circuit board on the RCA CC310.
Tools
- 
                  
                  - 
            Remove the six 7.9mm Phillips #0 screws on the back and bottom. 
- 
            Remove the one 3.8mm Phillips #0 screw on the bottom. 
- 
            Remove the two 7.5mm Phillips #0 screws on the back and bottom. 
 
- 
            
- 
                  
                  - 
            Remove 5.8mm Phillips #1 screw from the side button panel. 
- 
            Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw. 
 
- 
            
- 
                  
                  - 
            Pull the left panel away from the rest of the camcorder. 
- 
            Unplug the red speaker cable located at the rear of the device. 
 
- 
            
- 
                  
                  - 
            Unplug the two cables on the bottom of the effect button circuit board. 
- 
            Unplug the cable at the top left side of the motherboard. 
 
- 
            
- 
                  
                  - 
            Pull the plastic tabs away from the circuit board. 
- 
            Pull the board away from the camcorder. 
- 
            Use a spudger to help push the mini-circuit board away from the camcorder at the same time. 
- 
            Unplug the cable in the middle of the effects board. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.