Introduction
Tools
- 
                  
                  - 
            Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component. 
 
- 
            
- 
                  
                  - 
            Locate and release the flap on the side of your device's mount. This will allow you to slide the adjustable portion of the mount. 
 
- 
            
- 
                  
                  - 
            Using a #4.0 flathead screwdriver, unscrew your mount from the bottom and remove the 1.2cm screw. 
 
- 
            
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.