Introduction
Steps for removing the back half of the case and replacing it with a new one.
Tools
- 
                  
                  - 
            Slide the lock switch to the right so that it is in the unlocked position. 
- 
            Use your finger to slide the battery hatch in the direction of the downward arrow so that the hatch is open. 
 
- 
            
- 
                  
                  - 
            Open the battery hatch and then the black cover to expose the battery compartment. 
- 
            Remove the battery. 
 
- 
            
- 
                  
                  - 
            Use the Phillips #00 screwdriver to remove the three 2.8 mm screws on the bottom of the camera. 
 
- 
            
- 
                  
                  - 
            Place the camera on a flat surface with the front side facing down. 
- 
            Use the spudger to flip up the retaining flap and slide the ribbon cable out of the connector. 
- 
            Hold down on the camera's metal casing with one hand. Using your other hand, remove the back case from the rest of the camera. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.