Oster 6329 Outer Shell Removal

Written By: Isaac Williams
  • Comments: 1
Oster 6329 Outer Shell Removal

Difficulty

Easy

Steps

5

Time Required

3 - 5 minutes

Introduction

Removing the outer shell is crucial to repairing any component of your toaster and must be done first before attempting any other guide.

  1. cas6Ym1bsyZhOhvc
    cas6Ym1bsyZhOhvc
    esiNZOrcYVRyOVpK

    • Using the Phillips-head #2 screwdriver, unscrew the three 1cm Phillips-head screws on the plastic base of the toaster to separate the outer metal shell from the plastic base.

  2. fKH2aIprsLIjj3rX

    • Push the plastic push-down handle down and pull the plastic handle straight from metal arm.

    It really helped me to use a heat gun to warm up the handle a tiny bit.

    KC Embrey -

  3. tMLHBlhRqrivVWLZ

    • Loosen the outer metal shell from the plastic base by holding the plastic base while pulling up on the metal shell.

    • Only lift the outer shell a little so as not to disconnect the cables that connect the circuit board.

  4. jqfAdXcEnHW2Yllg
    jqfAdXcEnHW2Yllg
    BVQOZSvaw6JUYIcR

    • Disconnect the cable clips from the circuit board using the tweezers to free the outer metal shell from the plastic base.

  5. KIuoITDCUvQcpOYH
    KIuoITDCUvQcpOYH
    2RG2cP3tBtfSSYN2

    • Lift the top outer metal shell.

    • Carefully lift the outer metal shell at an angle so as not to damage the components in the front of the toaster.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Isaac Williams

Member since: 24/01/14

225 Reputation

0 comments