Olympus VR-350 LCD Screen Replacement

Written By: Chloe
  • Comments: 0
Olympus VR-350 LCD Screen Replacement

Difficulty

Moderate

Steps

7

Time Required

15 - 30 minutes

Introduction

This guide will help you replace your LCD screen.

  1. v2IDfjfmWpgNqHB6
    v2IDfjfmWpgNqHB6
    VyrNUD2NDELYlbpI

    • Remove the two 4mm screws from each side of the camera with a Phillips PH000 screwdriver.

  2. uRSrihr2sCXj3utt

    • Remove the four 4mm screws from the bottom of the camera with a Phillips PH000 screwdriver.

  3. Ns2XHBZMvOFb5AIN
    Ns2XHBZMvOFb5AIN
    Bn6bAdTRRgU4MOBg
    QRj5oxsRFMKBiTpZ

    • Use the plastic opening tools and your fingers to pry the front plate from the camera.

    • You might need to open the battery cover to remove the front plate.

  4. FVwJvNDbrXQdJKnV
    FVwJvNDbrXQdJKnV
    SNmPsHaXNYkZaea2

    • Use your fingers to pry open the back cover.

    • When you remove the back of the camera, the button membrane might fall out. Don’t lose this sheet.

    • The LCD screen is connected to the body of the camera by an orange ribbon cable. Don’t pull this ribbon cable out.

  5. QO5YQIrJ4XTcGIkB
    QO5YQIrJ4XTcGIkB
    1bXJIG3uCEHixFoI

    • Using the Phillips PH000 screwdriver, remove the 4mm screw from the bottom left corner of the button plate located under the button membrane.

  6. WJBIg1LmwILSG4n2

    • Pull the button pad up to fully reveal the visible ribbon cable.

    • You might need to bend the button pad out of the way.

  7. MhHNmeSpVZXUedLE

    • Pull out the LCD screen and the ribbon cable.

    • The ribbon cable should be easy to pull out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Chloe

Member since: 23/02/15

112 Reputation

0 comments