Introduction
Prerequisite Only
Tools
-
-
Locate the side of the camera with the connector cover.
-
Remove the 2 Phillips #00 4.6mm casing screws.
-
-
-
Open the connector cover by sliding the tab labeled lock to revile orange.
-
Slide the connector cover lock to revile orange and the door will spring open.
-
Remove the single internal Phillips #00 3.77mm screw.
-
-
-
Close the door to gain access to the casing.
-
Use your fingers to remove the black plastic casing that surrounds the connector door.
-
Use your fingers to remove the next black plastic piece .
-
Remove the two screws revealed
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
