Nikon Coolpix S630 Back Cover Replacement

Written By: Anna Katrina
  • Comments: 0
Nikon Coolpix S630 Back Cover Replacement

Difficulty

Easy

Steps

6

Time Required

5 minutes

Introduction

This guide will show you the proper steps to take apart the back metal casing from your Nikon Coolpix S639.

  1. NJEaiAJgWSsjEhpl

    • The battery compartment is located on the bottom of the camera.

    • Place your thumb on the battery door.

    • Slide the door away from the camera in the direction the arrow points to.

  2. 25iLjt3MANUhMmPP

    • Slide the yellow tab towards the back of the camera.

    • The battery should pop out.

    • Remove the battery.

  3. LNmnvxXEnMWyTjr1

    • Press the memory card down into the camera.

    • The memory card should pop out.

    • Remove the memory card.

  4. kBBihSkOehNGdAwe
    kBBihSkOehNGdAwe
    lJ2FDT5laV5WbXPj
    cJ6l2DjTFkHc4muY

    • Unscrew the two 3.5mm Phillips screws from the side with the AV outlet.

    • Unscrew the 3.5mm Phillips screw from the opposite side of the camera.

    • Unscrew the six 3.5mm Phillips screws from the bottom of the camera.

  5. K1UdrrDEEkDl6Jbn

    • Carefully remove the back casing from the camera.

    • Be mindful when removing the back casing as there is a ribbon that still connects the back casing to the motherboard.

  6. MGBDKqi2SVMEnUxX
    MGBDKqi2SVMEnUxX
    jjcfR2aUY62TVZaj

    • Place the plastic opening tool underneath the ribbon tab as shown. Gently lift the tab up.

    • Gently pull the ribbon from the logic board with tweezers.

    • With the ribbon disconnected, the back casing should now be detached from the rest of the camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Anna Katrina

Member since: 18/04/13

28 Reputation

0 comments