Introduction
This guide is to be used to install the wrist strap holder in the case that the holder becomes damaged or no longer functioning properly due to overuse. A Phillips screwdriver will be needed to complete this installation.
Tools
-
-
Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.
-
This will allow for the wrist strap to be pulled through the wrist strap holder.
-
-
-
Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.
-
This will cause the Battery/SD cover to pop open.
-
-
-
On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.
-
To reassemble your device, follow these instructions in reverse order.
