Introduction
This guide is needed to replace the mounting clips if they do not securely hold the camera in its mount. Make sure the device is unplugged before opening.
Tools
-
-
Lift the front of the case slowly, as there is an antenna cable attached to the motherboard.
-
Carefully disconnect the antenna cable from the motherboard. You will feel this cable "pop" out of place when disconnected.
-
-
-
Using a Philips #0 screwdriver, remove the four 4 mm screws that are attaching the mounting clips to the case.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
