Introduction
This guide is used to replace the motherboard of the Nest Dropcam Pro if yours has stopped working. Make sure the device is unplugged before opening.
Tools
- 
                  
                  - 
            Lift the front of the case slowly, as there is an antenna cable attached to the motherboard. 
- 
            Carefully disconnect the antenna cable from the motherboard. You will feel this cable "pop" out of place when disconnected. 
 
- 
            
- 
                  
                  - 
            Insert a spudger tool under the micro-USB port and lift to separate the motherboard from the back case. 
 
- 
            
- 
                  
                  - 
            Pull the motherboard away from the back case. 
- 
            Unplug the red and black cable connecting the motherboard to the back case. 
 
- 
            
- 
                  
                  - 
            Lift the lens and LED assembly away from the motherboard. 
- 
            Unplug the yellow and white cable from the motherboard. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
7 comments
where we can get the mother board to replace
I need this too
Where can I get the motherboard
xtogamba -
Can't find it either. Silly to write an entire article for credit if parts arent actually available.