Introduction
Has your stereo blown out one or both of your tweeters? Use this guide to help you replace them.
Tools
- 
                  
                  - 
            Take your flat head screwdriver and gently pry off the plastic grille covering your tweeter. 
- 
            There are 4 clips holding the grille down, 1 in each corner. Be careful not to break them. 
 
- 
            
- 
                  
                  - 
            Take your offset screwdriver and unscrew the screws holding down the tweeter bracket. 
- 
            Some models and years have 2 screws, others have 4. Remove them all. 
 
- 
            
- 
                  
                  - 
            If your tweeter only has 2 screws, attach a zip tie through the other holes and over the tweeter to help secure it in place. 
- 
            Cut off the excess tie. 
 
- 
            
- 
                  
                  - 
            Take any excess cable and fold it neatly so that it will fit down the hole below the tweeter. 
 
- 
            
- 
                  
                  - 
            Place the new tweeter and bracket assembly back into the dashboard. 
- 
            Make sure the orientation is how you would like it, and that the holes of the bracket line up with the holes in the dashboard. 
 
- 
            
- 
                  
                  - 
            Place the screws from the original tweeter back in their holes and tighten them with the offset screw driver. 
 
- 
            
You have succesfully replaced your tweeter. Follow the same steps to do the other side and test your stereo to make sure they are installed properly.