GE Profile Refrigerator PFSS6NKW Fresh Food Evaporator Cover Replacement

Written By: Matt Zieminski
  • Comments: 0
GE Profile Refrigerator PFSS6NKW Fresh Food Evaporator Cover Replacement

Difficulty

Easy

Steps

4

Time Required

10 minutes

Introduction

The fresh food evaporator cover is held to the back wall of the refrigerator with a Phillips-head screw and 2 tabs.

    • Remove the 2 fruit and vegetable drawers and the shelves that are in front of the evaporator cover.

    • Using a small flat blade screwdriver, pry off the cap from the top of the shelf angle.

    • Remove the 2 Phillips-head screws that attach the shelf angle to the cover.

    • Remove the 2 Phillips-head screws that hold the evaporator cover to the back wall.

    • Grasp the shelf angle near the bottom and pull it out and down.

    • Behind the cover there is a recessed area in the back wall that houses the evaporator assembly. The top of the cover is inserted into the top of the recess and the sides have small arrows that indicate the location of 6 tabs that lock into the recess.

    • Pull the cover out at the bottom, then lower the cover.

    • Turn the front of the cover towards the icemaker and disconnect the evaporator fan motor wire harness.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matt Zieminski

Member since: 23/02/15

40749 Reputation

0 comments