Disassembling RCA CC310 Left Cover

Written By: Ashley Katchadourian
  • Comments: 0
Disassembling RCA CC310 Left Cover

Difficulty

Moderate

Steps

4

Time Required

10 - 15 minutes

Introduction

This guide will instruct you to take the left cover off of the camcorder.

  1. HeZEXwM2sRWiGMvR
    HeZEXwM2sRWiGMvR
    1lUxaOJDvH3XcBKa

    • Remove the six 7.9mm Phillips #0 screws on the back and bottom.

    • Remove the one 3.8mm Phillips #0 screw on the bottom.

    • Remove the two 7.5mm Phillips #0 screws on the back and bottom.

  2. p2UtppAT1HrZEpQ3
    p2UtppAT1HrZEpQ3
    S4wmGQhsLVO5RcMK

    • Remove 5.8mm Phillips #1 screw from the side button panel.

    • Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw.

  3. 1sWEswjyuTUUhLgU
    1sWEswjyuTUUhLgU
    5NgXWwyFhRAhXOIx

    • Pry along the seam on the top side near the buttons with a spudger.

  4. 4AyCOUiguDMkJeEE
    4AyCOUiguDMkJeEE
    ccjnRcwwVURpRNWx

    • Pull the left panel away from the rest of the camcorder.

    • Unplug the red speaker cable located at the rear of the device.

    • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ashley Katchadourian

Member since: 20/01/11

133 Reputation

0 comments