Disassembling Olympus Stylus 725 SW Back Panel

Written By: Bobby Hodges
  • Comments: 0
Disassembling Olympus Stylus 725 SW Back Panel

Difficulty

Moderate

Steps

3

Time Required

10 - 15 minutes

Introduction

Use this guide to remove the back panel to access the components inside.

  1. jZusoFg6N23T2ScO
    jZusoFg6N23T2ScO
    pMdBNJg2Iiyplfm5

    • The battery is located on the bottom of the camera.

    • Remove the battery by placing your thumb on the bottom flap and sliding the release button away from the side the lens is on. (The screwdriver is simply used as a reference point, no screws need to be removed)

    • If the battery is dead, charge it for 60-90 minutes.

    • When installing a charged battery, align the battery appropriately. The positive signs and negative should line up.

  2. uGaGwC1IHUHdk1NH
    uGaGwC1IHUHdk1NH
    MLRW6dYORhHOsmvS
    QKerNhfH6JIifoXm

    • Remove the four 3 mm long cover screws at the corners of the camera using a Phillips #00 screwdriver.

    • Remove the 2 mm long screws securing the sides of the camera which holds the back panel using a Phillips #00 screwdriver.

  3. SMIlB5Acli3BhpJM
    SMIlB5Acli3BhpJM
    mwJSjmb6YGaTAEhl

    • Be careful when removing the back cover; you will need to detach the connecting ribbons. Use tweezers if necessary.

    • Detach the ribbons using your thumb, sliding them out of their slots.

    • Set the back panel face up to keep the ribbons from touching anything.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Bobby Hodges

Member since: 19/04/10

49 Reputation

0 comments