Introduction
This guide will show how to disassemble the grip for replacing the trigger or motor armature.
-
-
Remove the M3x16mm T10 screw from the back of the grip. Keep it separate from the rest of the grip screws
-
Remove the six M3.63x19 T15 screws from the grip.
-
-
-
Remove the top half of the grip.
-
Turn the saw over and locate the power connectors to the motor.
-
Use needle nose pliers to remove the spade connectors. Take care not to grab the wires on removal, only the end of the spade terminal.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
