D-Link HD Wi-Fi Camera Motherboard Replacement

Written By: Morgen Jaques
  • Comments: 2
D-Link HD Wi-Fi Camera Motherboard Replacement

Difficulty

Easy

Steps

3

Time Required

5 minutes

Introduction

This guide will show how to take apart a D-Link DCS 936L Wi-Fi security camera and remove the motherboard using an opening tool and a Philips 00 screwdriver. There are not many loose pieces making this a quick process as long as you're careful.

  1. CcvU2FpooknuBier

    • Place the camera upwards between your thumb and first finger.

    • Tilt the camera to the best position and loosen the captive linings using a plastic opening tool.

    • Slide the top cover outwards to separate the upper section from the lower lid using the plastic opening tool.

  2. Q3vu5utn5pXfPMqM
    Q3vu5utn5pXfPMqM
    41ToqFH1OdiBLvHV

    • Remove the 6.0mm Phillips #00 screws that secure the back cover to the inner frame.

    • Lift the rear lid upwards using your fingers and separate it from the internal components and motherboard.

    After removing the screws, there are 4 tabs holding the back cover on. Each tab is located at the edge of a vent. Pry at each point to remove the back cover. Take care not to damage the Micro SD card holder.

    Forrest -

  3. OMHBaRSjSWBQUoqo
    OMHBaRSjSWBQUoqo
    JtiAxnJMyCAhbvjh

    • Unscrew the motherboard from the frame. There are 3 Phillips #00 5.0mm screws holding it in place.

    • Then (gently!) remove the motherboard and the lens with your fingers.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Morgen Jaques

Member since: 28/09/17

533 Reputation

One comment

Where can I get the replacement motherboard? Been trying to search online, but to no avail.

Azlin Rahim -